TECHNICAL SERVICE

Impact Engraving Machines
 

Replacing tip level sensor:

​

- Instructions for replacing a worn tip level sensor for SAUNO Graphic-3KP / -3KS machines.

- Adjusting the position of the level sensor with error 8 "Sensor R too low" and error 9 "Sensor R close to the needle."

​

Cleaning and lubricating the fan of the motherboard

When the SAUNO Graphic-3KP machine is operating in a dusty environment, it may be necessary to clean the fan on the control board and lubricate the fan bearing. This simple operation takes only a few minutes.

​

Laser machines

​

Optics cleaning. SAUNO laser machine Graphic-3KL.

Film content:

​

- The device optical system.

- Check the air compressor.

- Cleaning the focusing lens.

- Mirror cleaning.

​

Adjust focus. SAUNO Graphic-3KL laser machine.
 

Film content:

​

- How to set focal length.

- In what cases it is required to check the focus

- How to check that the focus is set correctly.

- How to adjust the system.

​

​

Optics adjustment. SAUNO laser Graphic-3KL machine.

Film content:

​

- What is the adjustment and what is it for.

- How to set up a test laser pulse.

- Three stages of adjustment:

1. Setting the parallelism of the beam along the X axis.

2. Setting the parallelism of the beam along the Z axis.

3. Adjust the beam to the center of the lens.

​